320 XT PLUS High-Performance KIT 3500k+660nm

CC module*

Product video

Description

LED-TECH.DE 320 XT PLUS High-Performance KIT 3500k+660nm

The Samsung LM301B is currently one of the most efficient LEDs on the market and exceeds the 200lm/W limit.

The LED-TECH.DE 320 XT PCBs offer you completely new possibilities to realize demanding applications. Through the sockets you can easily extend your application almost infinitely.

Easy feeding without soldering! The insulated conductor is simply inserted into the clamping point as far as it will go and automatically fixed securely. Please use solid and stripped wires.

This KIT includes:

• 1x LED-TECH.DE 320 XT PLUS Board in (LM301B) + 660nm Hyper-Red (Osram OSLON Square)
• 4 Slot Nuts
  
• 6 Flat Washer (incl. 2 reserves flat washes)
  

The advantages at a glance:

- up to 218 lm/W
- easy installation
- high luminous flux
- CRI up to 94 possible
- individually stackable
- based on constant current
- 308x Samsung LEDs per board + 12 Osram-LEDs
- very good price / performance ratio
- fast and easy handling through plug-in system
- optimized surface illumination, e.g. grow, advertising space
- solderless PCB with sockets for rigid strands (0.2 - 0.75 mm²).
- 2-Channel PCB each channel individually controllable via a separate power supply

The values shown in the table are averages of the 660nm LEDs (Osram OSLON Square hyper-red).

Recommended:
If Channel 1 (3500K LEDs) operates at 3.5A, Channel 2 (660nm LEDs) should be operated at a maximum of 700mA.

For the boards we can recommend the following power supplies:

SYSTEM250 compatibility
The board offered here is 100% compatible with our SYSTEM250 construction kit. Our support will gladly assist you in the planning/design of your personal SYSTEM250 application. The gallery shows a sample composition.

Successful usage of high power LEDs:

Heat management
Applications with high power LEDs need enduring, adequate and plane heat conduction from the first moment of use. It is very important and neccessary to get the heat off the devices to ensure the maximum light output, lifetime and efficiancy.

Drive management
LEDs should be run with a constant current in addition to the manufacturers recommendations. To ensure this we recommend to take constant current power supplies because resistors are always a risk factor in high power LED applications.

IP protection
Unless otherwise stated, the modules are not protected against high humidity or splashing water. If LEDs are used in areas that require increased protection, this must be manufactured according to the requirements.

EMC protection
LEDs are sensitive against heat and electric charge. Please avoid any kind of short circuits or electric discharge to the illuminant. The chip can be damaged or even destroyed.

Storage / JEDEC level
The storage temperature should be from -30°C up to + 80°C in dry ambience. After opening a sealed bag the content should be mounted rapidly. Once absorbed humidity can be removed by tempering the LEDs in some cases. More information can be found in the manufacturers datasheets or on the manufacturer homepages.

Soldering conditions
Each LED has its own soldering conditions that the user should pay attention to. After the launched lead free processing specifications many standarts have changed. Information about recommended soldering can be found in the manufacturers datasheets or on the manufacturer homepages.