Phillips screwdriver (not included in the delivery)
1 x XT boards
2 Mark the positions of the slot nuts
The illustration shows the assembly on a 29.5x50cm frame for a XT board.
The slot nuts will be inserted at the red marked positions.
Turn the frame upside down and place the XT Board on it. Now you can mark the positions of the slot nuts with a pencil. To insert the slot nuts, please remove the XT Board from the frame.
3 Insert slot nuts
The following steps you will repeat on all before marked positions.
Press the slot nut sideward into the profile and tilt it.
Insert a small screw driver into the slot nut. Please be carefully, don't damage the thread!
Now turn the screw driver carefully so that the slot nut turn upwards inside the profile.
4 Prepare screws
Put the transparent flat washer on the M4 screws.
5 Mount XT Board
Place the XT Board on the frame again. Tighten all prepared screws on all four slot nuts. Please be careful, don't over tighten the screws. The acrylic glass can break!
6 Prepare the XT board connection
After mounting the boards, turn the frame upside down. Please take care, that the frame lay on a flat surface (use a soft pad if necessary).
Never put pressure on the LEDs.
Press the lever of the clamp down, e.g. with the help of a flat-blade screwdriver.
Push the cable into the clamp as far as it will go.
Press the second lever down as well.
Push the second cable into the clamp as far as it will go.
Note correct polarity. See first picture.
7 connect boards
Now connect the sockets with each other.
Repeat the steps until all boards are assembled and connected as shown in the picture.