Unit | Value | ||
---|---|---|---|
Light color | blue | ||
Beam | 80° | ||
Height | 3.85mm | ||
Width | 16.0mm | ||
Length | 45.0mm | ||
Unit | min. | typ. | max. |
Lumen | 4.2lm | 21lm | 50.4lm |
Wavelength | 470nm | ||
Voltage | 2.75V | 3.2V | 3.5V |
Current | 20mA | 350mA | 1000mA |
Datasheet | 2.09 MB |
The latest addition to the SYSTEM range of LED-TECH.DE.
The Slider modules are individually placeable Plug&Light modules available with different LED types, light colors and color temperatures. The pcbs can be repositioned and fixed as often as required without any damage by means of sliding nuts sliding in the profile. A special thermal pad (not included in the delivery) on the bottom not only provides non-slip grip but also optimal permanent heat dissipation.
*We distinguish the modules between CC and CV modules. Please note the product subtitle.
he Osram OSLON SSL is predestinated for lighting applications with high demands. Because of the wide viewing angle of 80° many applications do not need additional secondary optics anymore.
Features
Successful usage of high power LEDs:
Heat management
Applications with high power LEDs need enduring, adequate and plane
heat conduction from the first moment of use. It is very important and
neccessary to get the heat off the devices to ensure the maximum light
output, lifetime and efficiancy.
Drive management
LEDs should be run with a constant current in addition to the
manufacturers recommendations. To ensure this we recommend to take
constant current power supplies because resistors are always a risk
factor in high power LED applications.
IP protection
Unless otherwise stated, the modules are not protected against high humidity or splashing water. If LEDs are used in areas that require increased protection, this must be manufactured according to the requirements.
EMC protection
LEDs are sensitive against heat and electric charge. Please avoid any
kind of short circuits or electric discharge to the illuminant. The chip
can be damaged or even destroyed.
Storage / JEDEC level
The storage temperature should be from -30°C up to + 80°C in dry
ambience. After opening a sealed bag the content should be mounted
rapidly. Once absorbed humidity can be removed by tempering the LEDs in
some cases. More information can be found in the manufacturers
datasheets or on the manufacturer homepages.
Soldering conditions
Each LED has its own soldering conditions that the user should pay
attention to. After the launched lead free processing specifications
many standarts have changed. Information about recommended soldering can
be found in the manufacturers datasheets or on the manufacturer
homepages.