OSRAM Oslon SSL 120 Hyper Red Plug&Light Star (Horticulture)

GH CSSPM1.24 SSL 120

Optics

Description

Osram Oslon SSL120 Plug&Light Star
Solderless Star-PCB with WAGO PUSH WIRE® Technology

Easy feeding without soldering!
The insulated conductor is simply inserted into the clamping point as far as it will go and automatically fixed securely.

Features:

• Connection technology: Wago PUSH WIRE®
• Strip length: 6 till 7,5 mm
• Solid single wire conductor (0,5 mm²/20 AWG)
• package: SMt ceramic package with silicon resin with lens
• feature of the device: small size high-flux LED for slim designs
• wavelength: Hyper Red
  
• viewing angle: 120°
• technology: Thinfilm InGaAlP
• soldering methods: reflow soldering
• ESD-withstand voltage: up to 8 kV acc. to JESD22-A114-D

Please use solid wires and make sure that you have stripped the wire.

Successful usage of high power LEDs:

Heat management
Applications with high power LEDs need enduring, adequate and plane heat conduction from the first moment of use. It is very important and neccessary to get the heat off the devices to ensure the maximum light output, lifetime and efficiancy.

Drive management
LEDs should be run with a constant current in addition to the manufacturers recommendations. To ensure this we recommend to take constant current power supplies because resistors are always a risk factor in high power LED applications.

IP protection
Unless otherwise stated, the modules are not protected against high humidity or splashing water. If LEDs are used in areas that require increased protection, this must be manufactured according to the requirements.

EMC protection
LEDs are sensitive against heat and electric charge. Please avoid any kind of short circuits or electric discharge to the illuminant. The chip can be damaged or even destroyed.

Storage / JEDEC level
The storage temperature should be from -30°C up to + 80°C in dry ambience. After opening a sealed bag the content should be mounted rapidly. Once absorbed humidity can be removed by tempering the LEDs in some cases. More information can be found in the manufacturers datasheets or on the manufacturer homepages.

Soldering conditions
Each LED has its own soldering conditions that the user should pay attention to. After the launched lead free processing specifications many standarts have changed. Information about recommended soldering can be found in the manufacturers datasheets or on the manufacturer homepages.