MegaStrip 50cm with 252 LEDs 3000K

Very homogeneous and extremly bright LED stripe

Description

Extreme homogeneous LED module with onboard fasteners for fast & easy mounting!

The MegaStrips are assembled with a huge quantity of 252x SMDs on a 1,5mm aluminium core PCB. The width of 24mm let them perfectly fit into our COVERLINE profiles (LT-1512 and LT-1513) for example.

The modules can easily be driven in series connection by using the onboard fasteners. There is no doubt about the absolutely homogenous illumination of course. Mounting onto a profile or other heat conducting surface can be done by gluing or using the numerous mounting holes.

On 1m length the MegaStrips achieve an average of 2600 lumens what makes them a perfect alternative to common NEON lighting.

The features:

• Extreme brightness: 1200 lumens
• Very homogeneous viewing angle (120°)
• Perfectly for our Coverline Profiles
  
• Easy to handle: Simply connect to 24V DC and that's it!

Typical points of use:

• Architectural lighting
• Modulare systems
• Ceiling lighting
• Indoor lighting
• many more

Successful usage of high power LEDs:

Heat management
Applications with high power LEDs need enduring, adequate and plane heat conduction from the first moment of use. It is very important and neccessary to get the heat off the devices to ensure the maximum light output, lifetime and efficiancy.

Drive management
LEDs should be run with a constant current in addition to the manufacturers recommendations. To ensure this we recommend to take constant current power supplies because resistors are always a risk factor in high power LED applications.

IP protection
Unless otherwise stated, the modules are not protected against high humidity or splashing water. If LEDs are used in areas that require increased protection, this must be manufactured according to the requirements.

EMC protection
LEDs are sensitive against heat and electric charge. Please avoid any kind of short circuits or electric discharge to the illuminant. The chip can be damaged or even destroyed.

Storage / JEDEC level
The storage temperature should be from -30°C up to + 80°C in dry ambience. After opening a sealed bag the content should be mounted rapidly. Once absorbed humidity can be removed by tempering the LEDs in some cases. More information can be found in the manufacturers datasheets or on the manufacturer homepages.

Soldering conditions
Each LED has its own soldering conditions that the user should pay attention to. After the launched lead free processing specifications many standarts have changed. Information about recommended soldering can be found in the manufacturers datasheets or on the manufacturer homepages.