|from 1||15,04 €||17,90 €|
9x Samsung LH351H Far-Red (730nm) on SYSTEM Slider
The latest addition to the SYSTEM range of LED-TECH.DE.
The Slider modules are individually placeable Plug&Light modules available with different LED types, light colors and color temperatures. The pcbs can be repositioned and fixed as often as required without any damage by means of sliding nuts sliding in the profile. A special thermal pad (not included in the delivery) on the bottom not only provides non-slip grip but also optimal permanent heat dissipation.
*We distinguish the modules between CC and CV modules. Please note the product subtitle.
|0.100 A||14.76 V||1.48 W|
|0.350 A||16.38 V||5.73 W|
|0.700 A||18.09 V||12.66 W|
|1.000 A||19.17 V||19.17 W|
|0.100 A||0 lm||0.00 lm/W|
|0.350 A||0 lm||0.00 lm/W|
|0.700 A||9 lm||0.71 lm/W|
|1.000 A||9 lm||0.47 lm/W|
Successful usage of high power LEDs:
Applications with high power LEDs need enduring, adequate and plane heat conduction from the first moment of use. It is very important and neccessary to get the heat off the devices to ensure the maximum light output, lifetime and efficiancy.
LEDs should be run with a constant current in addition to the manufacturers recommendations. To ensure this we recommend to take constant current power supplies because resistors are always a risk factor in high power LED applications.
Unless otherwise stated, the modules are not protected against high humidity or splashing water. If LEDs are used in areas that require increased protection, this must be manufactured according to the requirements.
LEDs are sensitive against heat and electric charge. Please avoid any kind of short circuits or electric discharge to the illuminant. The chip can be damaged or even destroyed.
Storage / JEDEC level
The storage temperature should be from -30°C up to + 80°C in dry ambience. After opening a sealed bag the content should be mounted rapidly. Once absorbed humidity can be removed by tempering the LEDs in some cases. More information can be found in the manufacturers datasheets or on the manufacturer homepages.
Each LED has its own soldering conditions that the user should pay attention to. After the launched lead free processing specifications many standarts have changed. Information about recommended soldering can be found in the manufacturers datasheets or on the manufacturer homepages.