50cm MIXED alu stripe with 60x Samsung LM301H ONE 3500K + 5x Osram OSLON Square hyper-red LEDs

60x Samsung LM301H ONE + 5x Osram Square

Description

50cm MIXED alu stripe with 60x Samsung LM301H ONE 3500K + 5x Osram OSLON Square hyper-red LEDs

The Samsung LM301 is currently one of the most efficient LEDs on the market and exceeds the 200lm/W limit.

Most compact high-power LED of the third generation of OSLON Square with well known superior robustness, high reliability, long lifetime and low thermal resistance.

The advantages at a glance:

- easy installation
- high luminous flux
- individually stackable
- based on constant current
- 60x Samsung LEDs per board
- 5x Osram LEDs per board
- very good price / performance ratio
- fast and easy handling through plug-in system
- optimized surface illumination, e.g. grow, advertising space

Scope of delivery:

Successful usage of high power LEDs:

Heat management
Applications with high power LEDs need enduring, adequate and plane heat conduction from the first moment of use. It is very important and neccessary to get the heat off the devices to ensure the maximum light output, lifetime and efficiancy.

Drive management
LEDs should be run with a constant current in addition to the manufacturers recommendations. To ensure this we recommend to take constant current power supplies because resistors are always a risk factor in high power LED applications.

IP protection
Unless otherwise stated, the modules are not protected against high humidity or splashing water. If LEDs are used in areas that require increased protection, this must be manufactured according to the requirements.

EMC protection
LEDs are sensitive against heat and electric charge. Please avoid any kind of short circuits or electric discharge to the illuminant. The chip can be damaged or even destroyed.

Storage / JEDEC level
The storage temperature should be from -30°C up to + 80°C in dry ambience. After opening a sealed bag the content should be mounted rapidly. Once absorbed humidity can be removed by tempering the LEDs in some cases. More information can be found in the manufacturers datasheets or on the manufacturer homepages.

Soldering conditions
Each LED has its own soldering conditions that the user should pay attention to. After the launched lead free processing specifications many standarts have changed. Information about recommended soldering can be found in the manufacturers datasheets or on the manufacturer homepages.