Unit | Value | ||
---|---|---|---|
Light color | cool-white | ||
Outer diameter | 20.0mm | ||
Beam | 125° | ||
Height | 3.76mm | ||
Unit | min. | typ. | max. |
Kelvin | 5500K |
Datasheet | 2.92 MB |
Binning & Labeling | 2.55 MB |
The new 20mm star pcb with 3 individually controllable CREE LEDs
XP-G3 LEDs are the ideal choice for lighting applications where high light output and maximum efficacy are required, such as LED light bulbs, outdoorlighting, portable lighting, indoor lighting and solar-powered
The XLamp XP-G3 LED bases upon the excellent performance of the original XP-G2 by increasing the lumen output up to 31% while providing a single die LED point source for precise optical control.
Values per LED | Current | Voltage | Lumen |
min. | 350 mA | 2.8 V | 172 lm |
max. | 2000 mA | 3.2 V | 735 lm |
The features:
- Max. drive current: 2000mA per LED
- ANSI-compatible chromaticity bins
- Low thermal resistance: 3°C/W
- Wide viewing angle: 125°
- Unlimited floor life at <= 30°C/85% RH
- Reflow solderable (JEDEC J-STD-020C)
- Electrically neutral thermal path
- UL® recognized component (E349212)
- RoHS- and REACh compliant
Successful usage of high power LEDs:
Heat management
Applications with high power LEDs need enduring, adequate and plane
heat conduction from the first moment of use. It is very important and
neccessary to get the heat off the devices to ensure the maximum light
output, lifetime and efficiancy.
Drive management
LEDs should be run with a constant current in addition to the
manufacturers recommendations. To ensure this we recommend to take
constant current power supplies because resistors are always a risk
factor in high power LED applications.
IP protection
Unless otherwise stated, the modules are not protected against high humidity or splashing water. If LEDs are used in areas that require increased protection, this must be manufactured according to the requirements.
EMC protection
LEDs are sensitive against heat and electric charge. Please avoid any
kind of short circuits or electric discharge to the illuminant. The chip
can be damaged or even destroyed.
Storage / JEDEC level
The storage temperature should be from -30°C up to + 80°C in dry
ambience. After opening a sealed bag the content should be mounted
rapidly. Once absorbed humidity can be removed by tempering the LEDs in
some cases. More information can be found in the manufacturers
datasheets or on the manufacturer homepages.
Soldering conditions
Each LED has its own soldering conditions that the user should pay
attention to. After the launched lead free processing specifications
many standarts have changed. Information about recommended soldering can
be found in the manufacturers datasheets or on the manufacturer
homepages.