Unit | Value | ||
---|---|---|---|
Outer diameter | 34.0mm | ||
Beam | 125° | ||
Height | 6.0mm | ||
Unit | min. | typ. | max. |
Lumen | 660lm | 3150lm | |
Kelvin | 2700K | 7000K | |
Voltage | 8.5V | 12V | |
Current | 700mA | 3000mA |
Datasheet | 1.09 MB |
Binning & Labeling | 1.36 MB |
The Cree XLamp XM-L2 on round PCB!
The aluminium PCB has been designed as small as possible to fit into a wide range of applications. The PCB is designed to be connected to the Ledil CUTE-3 optics which also fit into MR11 downlight for example because of their 35mm diameter. The PCBs have a new center hole as well as notches at the edge to forward possible connection cables to the back side very easily.
he XLamp XM-L LED is the industry’s highest performance,
single-die white lighting-class LED. XLamp XM-L is 20% more efficient
than XLamp XP-G at the same current, and can deliver 1000 lumens with
100 lumens per Watt efficacy. The XLamp XM-L LED offers Cree’s
industry-leading features: wide viewing angle, symmetrical package,
unlimited floor life and electrically neutral thermal path.
XLamp
XM-L LEDs can enable LED light into new applications that require tens
of thousands of lumens, such as high bay and high-output area lighting.
XM-L is also the ideal choice for lighting applications where high light
output and maximum efficacy are required, such as LED light bulbs,
outdoor lighting, portable lighting, indoor lighting and solar-powered
lighting.
Successful usage of high power LEDs:
Heat management
Applications with high power LEDs need enduring, adequate and plane
heat conduction from the first moment of use. It is very important and
neccessary to get the heat off the devices to ensure the maximum light
output, lifetime and efficiancy.
Drive management
LEDs should be run with a constant current in addition to the
manufacturers recommendations. To ensure this we recommend to take
constant current power supplies because resistors are always a risk
factor in high power LED applications.
IP protection
Unless otherwise stated, the modules are not protected against high humidity or splashing water. If LEDs are used in areas that require increased protection, this must be manufactured according to the requirements.
EMC protection
LEDs are sensitive against heat and electric charge. Please avoid any
kind of short circuits or electric discharge to the illuminant. The chip
can be damaged or even destroyed.
Storage / JEDEC level
The storage temperature should be from -30°C up to + 80°C in dry
ambience. After opening a sealed bag the content should be mounted
rapidly. Once absorbed humidity can be removed by tempering the LEDs in
some cases. More information can be found in the manufacturers
datasheets or on the manufacturer homepages.
Soldering conditions
Each LED has its own soldering conditions that the user should pay
attention to. After the launched lead free processing specifications
many standarts have changed. Information about recommended soldering can
be found in the manufacturers datasheets or on the manufacturer
homepages.